Excerpt

Measurement is required for developing lithographic processes and is fundamental to engineering and manufacturing control. The problem of accurate measurement is particularly significant for lithographers, where the extremely small features of state-of-the-art processes have pushed measurement capabilities to their limits, and, some might say, beyond. Some of the metrology issues and challenges faced by lithographers are discussed in this chapter.

9.1 Linewidth Measurement

A number of methods have been used to measure the dimensions of resist lines, as well as spaces and holes in resist. Optical methods were used in the earliest days of the semiconductor industry, but were replaced by 1990 by scanning electron microscopes as the primary tools for linewidth measurement. Consequently, these early types of optical methods are not discussed further in this book. However, for linewidth measurement, optical methods have returned in a new form, scatterometry, and this technique is discussed. A number of other methods for measuring linewidths are used in critical, specialized applications, and one of these, electrical linewidth measurement, is also included for discussion.

9.1.1 Linewidth measurement using scanning electron microscopes

The most common tool for measuring linewidths is the scanning electron microscope (SEM). Low-voltage SEMs are capable of measuring resist features in line. In the scanning electron microscope, electron beams are scanned across patterns on wafers. The voltage of the electron beams ranges from a few hundred volts to tens of thousands of volts. For measuring resist features, a typical range is 300-1000 volts. The incident beam is scattered, both elastically and inelastically, producing secondary and backscattered electrons. By commonly accepted definition, secondary electrons are those with energy less than 50 eV, while the backscattered electrons are those with energies closer to that of the incident beam. The secondary electrons created by inelastic scattering or the elastically backscattered electrons are detected synchronously with the scan of the incident beam (Fig. 9.1). Because the number and direction of the scattered electrons depend upon the material composition and topography of the features over which the incident beam is scanned, the intensity of the detected signal varies so that an image can be created.

© 2010 Copyright © 2010 Society of Photo-Optical Instrumentation Engineers (SPIE)

Access This Chapter

Access to SPIE eBooks is limited to subscribing institutions and is not available as part of a personal subscription. Print or electronic versions of individual SPIE books may be purchased via SPIE.org.

Related Content

Customize your page view by dragging & repositioning the boxes below.

Related Journal Articles

Related Book Chapters

Topic Collections

Advertisement
  • Don't have an account?
  • Subscribe to the SPIE Digital Library
  • Create a FREE account to sign up for Digital Library content alerts and gain access to institutional subscriptions remotely.
Access This Article
Sign in or Create a personal account to Buy this article ($20 for members, $25 for non-members).
Access This Proceeding
Sign in or Create a personal account to Buy this article ($15 for members, $18 for non-members).
Access This Chapter

Access to SPIE eBooks is limited to subscribing institutions and is not available as part of a personal subscription. Print or electronic versions of individual SPIE books may be purchased via SPIE.org.