|
In this work, the geometry of a 3D model of Cell-PP is designed on the basis of analytical Splines. Both the manufacturing procedure of Cell-PP films (bi-axial stretching) and the pressure expansion treatment were simulated in order to account for a realistic void distribution. The FEA is done on a 2D cross-section of the modelled film. The modelled mechanical response is analysed based on increasing mechanical load applied. The load-deflection curves obtained from the analysis are then compared to the experimental results acquired via Dynamical Mechanical Analyzer (DMA) to validate the model. Four types of Cell-PP films, expanded at different pressures, were used in this validation. The aim is to develop a model that describes the effect of morphological parameters on the stiffness of the films by simulating the manufacturing procedure. |
|
|
