The effect of laser ablation parameters on optical limiting properties of silver nanoparticles

Irmak Gursoy; Halime Gul Yaglioglu

doi:10.1117/12.2274000

Translator Disclaimer

6 September 2017 The effect of laser ablation parameters on optical limiting properties of silver nanoparticles

Irmak Gursoy, Halime Gul Yaglioglu

Author Affiliations +

Proceedings Volume 10374, Optical Modeling and Performance Predictions IX; 103740M (2017) https://doi.org/10.1117/12.2274000
Event: SPIE Optical Engineering + Applications, 2017, San Diego, California, United States

Abstract

This paper presents the effect of laser ablation parameters on optical limiting properties of silver nanoparticles. The current applications of lasers such as range finding, guidance, detection, illumination and designation have increased the potential of damaging optical imaging systems or eyes temporary or permanently. The applications of lasers introduce risks for sensors or eyes, when laser power is higher than damage threshold of the detection system. There are some ways to protect these systems such as neutral density (nd) filters, shutters, etc. However, these limiters reduce the total amount of light that gets into the system. Also, response time of these limiters may not be fast enough to prevent damage and cause precipitation in performance due to deprivation of transmission or contrast. Therefore, optical limiting filters are needed that is transparent for low laser intensities and limit or block the high laser intensities. Metal nanoparticles are good candidates for such optical limiting filters for ns pulsed lasers or CW lasers due to their high damage thresholds. In this study we investigated the optical limiting performances of silver nanoparticles produced by laser ablation technique. A high purity silver target immersed in pure water was ablated with a Nd:YAG nanosecond laser at 532 nm. The effect of altering laser power and ablation time on laser ablation efficiency of nanoparticles was investigated experimentally and optimum values were specified. Open aperture Zscan experiment was used to investigate the effect of laser ablation parameters on the optical limiting performances of silver nanoparticles in pure water. It was found that longer ablation time decreases the optical limiting threshold. These results are useful for silver nanoparticles solutions to obtain high performance optical limiters.

Citation Download Citation

Irmak Gursoy and Halime Gul Yaglioglu "The effect of laser ablation parameters on optical limiting properties of silver nanoparticles", Proc. SPIE 10374, Optical Modeling and Performance Predictions IX, 103740M (6 September 2017); https://doi.org/10.1117/12.2274000

ACCESS THE FULL ARTICLE