Commissioning of cryogenic preamplifiers for SAPHIRA detectors

Sean B. Goebel; Donald N. B. Hall; Shane Jacobson; Annino Vaccarella; Rob Sharp; Michael Ellis; Izabella Pastrana

doi:10.1117/12.2311513

16 July 2018 Commissioning of cryogenic preamplifiers for SAPHIRA detectors

Sean B. Goebel, Donald N. B. Hall, Shane Jacobson, Annino Vaccarella, Rob Sharp, Michael Ellis, Izabella Pastrana

Proceedings Volume 10709, High Energy, Optical, and Infrared Detectors for Astronomy VIII; 107090R (2018) https://doi.org/10.1117/12.2311513
Event: SPIE Astronomical Telescopes + Instrumentation, 2018, Austin, Texas, United States

Abstract

SAPHIRA detectors, which are HgCdTe linear avalanche photodiode arrays manufactured by Leonardo, enable high frame rate, high sensitivity, low noise, and low dark current imaging at near-infrared wavelengths. During all University of Hawaii Institute for Astronomy lab testing and observatory deployments of SAPHIRA detectors, there was approximately one meter of cables between the arrays and the readout controllers. The output drivers of the detectors struggled to stably send signals over this length to the readout controllers. As a result, voltage oscillations caused excess noise that prevented us from clocking much faster than 1 MHz. Additionally, during some deployments, such as at the SCExAO instrument at Subaru Telescope, radio-frequency interference from the telescope environment produced noise many times greater than what we experienced in the lab. In order to address these problems, collaborators at the Australia National University developed a cryogenic preamplifier system that holds the detector and buffers the signals from its outputs. During lab testing at 1 MHz clocking speeds, the preamplifiers reduced the read noise by 45% relative to data collected using the previous JK Henriksen detector mount. Additionally, the preamplifiers enabled us to increase the clocking frequency to 2 MHz, effectively doubling the frame rate to 760 Hz for a full (320x256 pixel) frame or 3.3 kHz for a 128x128 pixel subarray. Finally, the preamplifiers reduced the noise observed in the SCExAO environment by 65% (to essentially the same value observed in the lab) and eliminated the 32-pixel raised bars characteristic of radio-frequency interference that we previous observed there.

Conference Presentation

Citation Download Citation

Sean B. Goebel, Donald N. B. Hall, Shane Jacobson, Annino Vaccarella, Rob Sharp, Michael Ellis, and Izabella Pastrana "Commissioning of cryogenic preamplifiers for SAPHIRA detectors", Proc. SPIE 10709, High Energy, Optical, and Infrared Detectors for Astronomy VIII, 107090R (16 July 2018); https://doi.org/10.1117/12.2311513

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available