Fusion positioning method of optical measuring equipment and GNSS

Tiening Nie; Wei Zhang; Min Chai

doi:10.1117/12.2520675

Translator Disclaimer

12 March 2019 Fusion positioning method of optical measuring equipment and GNSS

Tiening Nie, Wei Zhang, Min Chai

Author Affiliations +

Proceedings Volume 11023, Fifth Symposium on Novel Optoelectronic Detection Technology and Application; 110230V (2019) https://doi.org/10.1117/12.2520675
Event: Fifth Symposium on Novel Optoelectronic Detection Technology and Application, 2018, Xi'an, China

Abstract

In order to expand the scope of exterior trajectory measurement system, it is required to make full use of various heterologous measuring elements to establish a joint positioning model with multi-system measurement information to make up the traditional positioning method. Meanwhile, there must be many redundant observations in the tracking measurement. It will improve the accuracy and continuity of target tracking measurement and optimize the comprehensive measurement level of the measurement and control system and unit efficiency by making rational use of these redundant measurements and processing with data fusion algorithm. The measuring angle and range of optical measuring unit and constraint equation of GNSS pseudo range measurement information were discussed in this paper. Optical and GNSS joint measurement model was established. The least square solution of this nonlinear equation was obtained with Newton iteration method. Finally, simulation data was used to verify the result. The result shows that the target position can be calculated by making use of the measured information of optical and GNSS unit in the minimum positioning condition, and the accuracy of fusion calculation result will improve correspondingly when there are many redundant measurement elements.

Citation Download Citation

Tiening Nie, Wei Zhang, and Min Chai "Fusion positioning method of optical measuring equipment and GNSS", Proc. SPIE 11023, Fifth Symposium on Novel Optoelectronic Detection Technology and Application, 110230V (12 March 2019); https://doi.org/10.1117/12.2520675

ACCESS THE FULL ARTICLE