Paper
15 November 2019 Experimental investigation on processing of fused silica microchannels by high repetition rate femtosecond laser
Author Affiliations +
Proceedings Volume 11175, Optifab 2019; 1117521 (2019) https://doi.org/10.1117/12.2536269
Event: SPIE Optifab, 2019, Rochester, New York, United States
Abstract
Femtosecond laser processing has been extensively used in micromachining, especially for the precision processing of hard and brittle materials. However, the precision of the materials ablated by femtosecond laser is not easy to control. This paper reports an experimental and theoretical study on the ablation characteristics of fused silica using high repetition rate femtosecond laser. An experimental study of microchannels milling on the fused silica was carried out. The influence of pulse energy, repetition rate, scanning velocity, scanning times on the size and morphology of the microchannels was obtained. Simultaneously, the experimental data on the depth and width of microchannels under different parameter combinations were acquired through the orthogonal experiment. The prediction model of aspect ratio was obtained by BP neural network algorithm. Finally, the verification test was established and showed that the experimental results were consistent with the theoretical results. It would provide a theoretical basis for further study on the microchannels fabrication of femtosecond laser.
© (2019) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Kai Liao, Wenjun Wang, Xuesong Mei, Bin Liu, and Aifei Pan "Experimental investigation on processing of fused silica microchannels by high repetition rate femtosecond laser", Proc. SPIE 11175, Optifab 2019, 1117521 (15 November 2019); https://doi.org/10.1117/12.2536269
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Femtosecond phenomena

Silica

Data acquisition

Evolutionary algorithms

Laser ablation

Micromachining

Neural networks

Back to Top