Paper
30 December 2019 Vertical directional coupler network using a-Si slope waveguides
V. Mittal, R. Petra, A. Tarazona, N. J. Dinsdale, A. Khokhar, M. Banakar, D. Thomson, O. L. Musken, G. T. Reed, H. M. H. Chong
Author Affiliations +
Abstract
A CMOS compatible three-dimensional (3D) integrated photonics circuit for multilayer silicon photonics is reported. Slopes with angles between 10o and 15° were created in the oxide layer using single step wet etching to connect the two Si waveguide layers. Amorphous Si (a-Si) deposited using hot wire chemical vapor deposition (HWCVD) at a temperature of 230°C was used to fabricate the device. Losses of 0.5 dB/slope were measured in the slope waveguides at 1310 nm wavelength. As a demonstration, we propose a 4x4 network switch using a-Si based vertical directional coupler.
© (2019) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
V. Mittal, R. Petra, A. Tarazona, N. J. Dinsdale, A. Khokhar, M. Banakar, D. Thomson, O. L. Musken, G. T. Reed, and H. M. H. Chong "Vertical directional coupler network using a-Si slope waveguides", Proc. SPIE 11200, AOS Australian Conference on Optical Fibre Technology (ACOFT) and Australian Conference on Optics, Lasers, and Spectroscopy (ACOLS) 2019, 112001W (30 December 2019); https://doi.org/10.1117/12.2542213
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Waveguides

Amorphous silicon

Directional couplers

Photonics

Switches

Electronics

Light wave propagation

Back to Top