Paper
1 July 1990 Technology for 8-m primary mirrors
Richard G. Bingham, David D. Walker, Francisco Diego
Author Affiliations +
Abstract
The cost of an 8-m telescope is still too high for most national observatories. Cost reductions must involve new technology for the primary mirror: its material and figuring, its mass, handling and the aluminizing plant. The present scheme addresses these problems using some features of the Keck technology, but is simplified. Consideration is given to a segmented mirror in which the segments are radially cut sectors. The sectors for an 8-m aperture will fit inside a 4-m aluminizing plant (which already exists on some sites, and in any event is cheaper than an 8-m plant). Zero-expansion material (glass-ceramic or fused silica) may be used. The model thickness is about 10 cm. The proposed method of production is to figure the whole set assembled as a single mirror. No cutting takes place after figuring.
© (1990) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Richard G. Bingham, David D. Walker, and Francisco Diego "Technology for 8-m primary mirrors", Proc. SPIE 1236, Advanced Technology Optical Telescopes IV, (1 July 1990); https://doi.org/10.1117/12.19228
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Mirrors

Telescopes

Polishing

Polishing equipment

Segmented mirrors

Space telescopes

Optical telescopes

RELATED CONTENT

Construction of the Keck Observatory
Proceedings of SPIE (July 01 1990)
University Of California Ten Meter Telescope Project
Proceedings of SPIE (November 04 1982)
A Ten-Meter Optical Telescope In Space
Proceedings of SPIE (August 20 1986)
Airborne Infrared Astronomy Telescope
Proceedings of SPIE (September 01 1974)

Back to Top