Translator Disclaimer
Paper
2 February 1993 Performance of an area scintillator detector
Author Affiliations +
Abstract
A two-dimensional position-sensitive neutron detector (PSD) was constructed using a scintillator attached to a position-sensitive photo-multiplier with 100 mm diameter. Position determination is based on charge division. Spatial resolution, gamma sensitivity, linearity, temperature dependence and radiation shielding have been investigated. The shaping amplifiers used in the detection electronics were optimized. Two kinds of scintillators were examined: LiI(Eu) crystal and Li-glass. Concerning the gamma sensitivity and resolution, the best performance was obtained using the LiI. A spatial resolution with full width half maximum of 1.3(1) mm was measured. A good shielding against gamma radiation was found to consist out of three layers: 5 mm of boron rubber, 5 cm of lead and 5 mm of boron rubber. The influence of the temperature on the PSD signal output was measured and indicates that a stabilization is necessary. The PSD will be used in a time-of-flight neutron reflectometer.
© (1993) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Victor O. de Haan and Ad A. van Well "Performance of an area scintillator detector", Proc. SPIE 1737, Neutrons, X Rays, and Gamma Rays: Imaging Detectors, Material Characterization Techniques, and Applications, (2 February 1993); https://doi.org/10.1117/12.138665
PROCEEDINGS
12 PAGES


SHARE
Advertisement
Advertisement
RELATED CONTENT

Impact of fano factor on position and energy estimation in...
Proceedings of SPIE (September 26 2013)
Compact gamma ray probe for breast imaging based on a...
Proceedings of SPIE (April 25 2000)
The other end of the scale Coded apertures in...
Proceedings of SPIE (November 19 2012)
Development of a hybrid gas detector phoswich for hard x...
Proceedings of SPIE (September 16 1994)
ASPEX: a prêt-à-porter all sky monitor
Proceedings of SPIE (June 15 2006)

Back to Top