Paper
22 January 1982 X-Ray-Induced Transient Attenuation At Low Temperatures In Polymer Clad Silica (PCS) Fibers
C. E. Barnes, J. J. Wiczer
Author Affiliations +
Abstract
A set of eight polymer clad silica (PCS) fibers from Quartz & Silice with varying water content, cladding thickness, and cladding material type have been exposed to 50 nsec wide X-ray pulses at different temperatures (-45°C, -25°C, 0°C, +25°C) in order to study the effect of fiber parameters and temperature on the extent of X-ray induced transient attenuation at typical LED wavelengths (820 nm, 900 nm, 940 nm, 1060 nm). Our results indicate that, relative to other fiber parameters, the presence of water suppresses the transient attenuation in these fibers especially at the longer wavelengths and lower temperatures. Both the peak transient attenuation, ap, and the normalized transient attenuation, α (t)/αρ, increased with decreasing temperature as one might expect for thermally-limited recovery processes. The peak trans-ient attenuation also increased with decreasing wavelength, with the wavelength dependence being stronger in the wet fibers. Within the limits of this experiment, the cladding characteristics had no effect on the fiber response to irradiation. Thus, in spite of the fact that the presence of water leads to greater intrinsic fiber attenuation between 900 nm and 1000 nm, its presence is beneficial to low temperature fiber behavior in an ionizing environment.
© (1982) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
C. E. Barnes and J. J. Wiczer "X-Ray-Induced Transient Attenuation At Low Temperatures In Polymer Clad Silica (PCS) Fibers", Proc. SPIE 0296, Fiber Optics in Adverse Environments I, (22 January 1982); https://doi.org/10.1117/12.932425
Lens.org Logo
CITATIONS
Cited by 2 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Signal attenuation

Optical fibers

Cladding

Data modeling

X-rays

Temperature metrology

Fiber optics

RELATED CONTENT


Back to Top