Paper
6 June 1997 Measurement of transverse strains with fiber Bragg gratings
Craig M. Lawrence, Drew V. Nelson, Eric Udd
Author Affiliations +
Abstract
In this paper, we present a method to measure two components of transverse strain in an optical fiber using a single Bragg grating written into high-birefringent, polarization- maintaining (PM) fiber. The reflected spectrum from this grating contains two peaks corresponding to the two orthogonal polarization modes of the fiber. If the axial strain and temperature in the fiber is known, then two components of transverse strain can be computed from the changes in wavelength of the two peaks. A Bragg grating written near 1300 nm in PM fiber was loaded in diametrical compression, and the changes in wavelength of the Bragg peaks were monitored using an optical spectrum analyzer. Transverse strains were computed from the changes in wavelength using available strain-optic coefficients for low-birefringent optical fiber. These strains are compared to finite element analysis predictions, and it is shown that the observed sensor response is greater than the response predicted by the low-birefringent analysis. A calibration factor is developed for the sensor to allow the determination of transverse strains from the measured wavelength shifts.
© (1997) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Craig M. Lawrence, Drew V. Nelson, and Eric Udd "Measurement of transverse strains with fiber Bragg gratings", Proc. SPIE 3042, Smart Structures and Materials 1997: Smart Sensing, Processing, and Instrumentation, (6 June 1997); https://doi.org/10.1117/12.275739
Lens.org Logo
CITATIONS
Cited by 58 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Sensors

Fiber Bragg gratings

Optical fibers

Finite element methods

Fiber optics sensors

Polarization

Calibration

Back to Top