Translator Disclaimer
Paper
11 July 1997 Sliced zone plate for hard x-ray sources: manufacturing and testing
Author Affiliations +
Abstract
Fresnel hard x-ray zone plate was manufactured by sputter- sliced technology to work on 2.29 A wavelength. Cu and Cr were used to create opaque and transparent zones. The experimental setup was prepared to investigate optical properties of obtained zone plate. The focusing effect was observed. The numerical methods and software were developed to simulate imaging properties of Fresnel zone plate. Experimental data was compared with calculations.
© (1997) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Victor E. Asadchikov, Valentin I. Beloglazov, Alexander V. Vinogradov, Dmitrii L. Voronov, V. V. Kondratenko, Yu. V. Kopylov, N. F. Lebedev, A. G. Ponomarenko, Alexei V. Popov, Andrei A. Postnov, and Anatoli I. Fedorenko "Sliced zone plate for hard x-ray sources: manufacturing and testing", Proc. SPIE 3113, Grazing Incidence and Multilayer X-Ray Optical Systems, (11 July 1997); https://doi.org/10.1117/12.278865
PROCEEDINGS
9 PAGES


SHARE
Advertisement
Advertisement
RELATED CONTENT

Two dimensional sub 5 nm hard x ray focusing with...
Proceedings of SPIE (September 27 2013)
Progress on multi order hard x ray imaging with multilayer...
Proceedings of SPIE (September 18 2015)
Advanced zone plate microfocusing optics
Proceedings of SPIE (November 06 1998)
Differential interference contrast x-ray microscopy
Proceedings of SPIE (December 20 2001)
Near field stacking of zone plates in the x ray...
Proceedings of SPIE (November 21 2002)

Back to Top