Paper
27 May 1982 Trilayer Bubble-Forming Optical Recording Media
G. A. N. Connell, R. I. Johnson, D. Kowalski, C. DePuy
Author Affiliations +
Proceedings Volume 0329, Optical Disk Technology; (1982) https://doi.org/10.1117/12.933389
Event: 1982 Los Angeles Technical Symposium, 1982, Los Angeles, United States
Abstract
An investigation was made of the possibilities of optical recording on bubble-forming metal/thermodegradeable-plastic bilayers incorporated in front-surface trilayer devices. Two distinct types of trilayer device were chosen for study. It was found that a device consisting of a 14 nm-thick metal layer, a 200 nm-thick thermodegradeable-plastic dielectric layer and a 100 nm-thick aluminum layer had promising properties. That is, a power of only 6.5 mW focussed into a 0.8 μm spot at 442 nm (the helium-cadmium laser line) was required to write a 5 MHz-pattern with 50% duty cycle. This pattern is observed with high contrast at 633 nm (the helium-near laser line), where the initial reflectivity is 0.9, and it provides signal to noise in a 30 kHz bandwidth of 45 dB. The trilayer device is also calculated to have the same writing sensitivity at 830 nm (the gallium arsenide laser line).
© (1982) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
G. A. N. Connell, R. I. Johnson, D. Kowalski, and C. DePuy "Trilayer Bubble-Forming Optical Recording Media", Proc. SPIE 0329, Optical Disk Technology, (27 May 1982); https://doi.org/10.1117/12.933389
Lens.org Logo
CITATIONS
Cited by 1 scholarly publication.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Reflectivity

Metals

Signal to noise ratio

Aluminum

Optical discs

Electronics

Light scattering

Back to Top