Translator Disclaimer
Paper
17 April 1998 Design and fabrication of optical thin film color splitting and combing components for projection display
Author Affiliations +
Proceedings Volume 3296, Projection Displays IV; (1998) https://doi.org/10.1117/12.305531
Event: Photonics West '98 Electronic Imaging, 1998, San Jose, CA, United States
Abstract
Optical thin film color splitting and combining components for 3 panel projection display were designed using TiO2 and SiO2 as high and low refractive index materials, respectively, and fabricated by reactive electron-beam deposition at a substrate temperature of 300 degrees C. The resulting coating performances on the brightness and color performance were analyzed by chroma meter. The correlations between these results and their spectral curves measured by spectrophotometer were discussed.
© (1998) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Chii Hua Lee, Sen Chrong Shiau, Rung-Ywan Tsai, and Fang Chung Ho "Design and fabrication of optical thin film color splitting and combing components for projection display", Proc. SPIE 3296, Projection Displays IV, (17 April 1998); https://doi.org/10.1117/12.305531
PROCEEDINGS
9 PAGES


SHARE
Advertisement
Advertisement
RELATED CONTENT

Design and pre-production analysis of optical coatings
Proceedings of SPIE (September 23 2015)
Elimination of the half wave hole for short wave pass...
Proceedings of SPIE (December 08 2004)
Properties of AlF3 and LaF3 films at 193nm
Proceedings of SPIE (October 06 2010)
Chiral supercavities
Proceedings of SPIE (July 09 2003)

Back to Top