Primary evaluation of proximity and resist heating effects observed in high-acceleration voltage e-beam writing for 180-nm-and-beyond rule reticle fabrication

Naoko Kuwahara; H. Nakagawa; Masa-aki Kurihara; Naoya Hayashi; Hisatake Sano; E. Maruta; T. Takikawa; Shigeru Noguchi

doi:10.1117/12.360208

25 August 1999 Primary evaluation of proximity and resist heating effects observed in high-acceleration voltage e-beam writing for 180-nm-and-beyond rule reticle fabrication

Naoko Kuwahara, H. Nakagawa, Masa-aki Kurihara, Naoya Hayashi, Hisatake Sano, E. Maruta, T. Takikawa, Shigeru Noguchi

Author Affiliations +

Proceedings Volume 3748, Photomask and X-Ray Mask Technology VI; (1999) https://doi.org/10.1117/12.360208
Event: Photomask and X-Ray Mask Technology VI, 1999, Yokohama, Japan

Abstract

Higher resolution and accuracy are required in e-beam lithography for reticle fabrication for coping with further advances in optical lithography. The trend is to use high acceleration voltage (50 kV) e-beam to improve spatial resolution. However, in the case of high acceleration e-beam writing, a drastic critical dimension (CD) change is caused by a strong proximity effect and a large resist heating effect. The proximity effect is caused by the increase in the back- scattering radius. The back-scattering radius was estimated by two independent observations of the CD variation of a monitor and the thickness variation of a partially developed resist. It is found to be ca. 15 nm. Using the shot time modulation as a proximity correction reduced the proximity effect to a small level: CD error due to the pattern density change remained within 10 nm. On the other hand, the resist heating effect is caused by the change in resist dissolution speed by the temperature rise of the resist. In reducing this effect, multi-pass writing is found to be effective. The range of the CD error of 2 micrometer lines-and-spaces in the writing field has been reduced from 22 nm to 6 nm by changing the writing from one pass to four passes for a conventional resist. Moreover, when a chemically amplified resist (CAR) is exposed through one-pass writing, the range of the CD error is found to be 8 nm. Therefore, the use of the CAR is effective in reducing the resist heating effect. Simulation software ProBEAM/3D and TEMPTATION were used to obtain three- dimensional resist profile and the transient temperature rise of the resist, respectively. Both provided results that agreed well with those by experiment.

Citation Download Citation

Naoko Kuwahara, H. Nakagawa, Masa-aki Kurihara, Naoya Hayashi, Hisatake Sano, E. Maruta, T. Takikawa, and Shigeru Noguchi "Primary evaluation of proximity and resist heating effects observed in high-acceleration voltage e-beam writing for 180-nm-and-beyond rule reticle fabrication", Proc. SPIE 3748, Photomask and X-Ray Mask Technology VI, (25 August 1999); https://doi.org/10.1117/12.360208

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

;

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE