Paper
12 November 1999 Fabrication of planar waveguides of poly(N-vinylcarbazole)
Fitri Fitrilawati, May On Tjia, Jochen Ziegler, Christoph Bubeck
Author Affiliations +
Proceedings Volume 3896, Design, Fabrication, and Characterization of Photonic Devices; (1999) https://doi.org/10.1117/12.370385
Event: International Symposium on Photonics and Applications, 1999, Singapore, Singapore
Abstract
Thin films of poly(N-vinylcarbazole) (PVK) were prepared by spincoating upon fused silica substrates. PVK was dissolved in dimethyl formamide (DMF) and processed at elevated temperatures. Thin films with the required thickness and low surface roughness were obtained by careful optimization of the preparation parameters, such as concentration, spinning speed and temperature of these spincoating process. The dispersion of refractive indices of PVk films was measured by reflectometry and by prism coupling at 633 nm and 1064 nm. The attenuation loss of slab waveguides was measured by monitoring the stray light of the guided mode with a diode array. The loss depends significantly on the relative ratio of surface roughness to thickness. As this ratio depends on preparation conditions, we succeeded in fabricating planar waveguides of PVK that had an attenuation loss of only 1 dB/cm at 633 nm.
© (1999) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Fitri Fitrilawati, May On Tjia, Jochen Ziegler, and Christoph Bubeck "Fabrication of planar waveguides of poly(N-vinylcarbazole)", Proc. SPIE 3896, Design, Fabrication, and Characterization of Photonic Devices, (12 November 1999); https://doi.org/10.1117/12.370385
Lens.org Logo
CITATIONS
Cited by 3 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Waveguides

Refractive index

Prisms

Surface roughness

Signal attenuation

Planar waveguides

Coating

Back to Top