Large-area mercuric iodide x-ray imager

George Zentai; Larry D. Partain; Raisa Pavlyuchkova; Gary F. Virshup; Asaf Zuck; Leonid Melekhov; O. Dagan; Alexander I. Vilensky; Haim Gilboa

doi:10.1117/12.465604

Translator Disclaimer

3 May 2002 Large-area mercuric iodide x-ray imager

George Zentai, Larry D. Partain, Raisa Pavlyuchkova, Gary F. Virshup, Asaf Zuck, Leonid Melekhov, O. Dagan, Alexander I. Vilensky, Haim Gilboa

Author Affiliations +

Proceedings Volume 4682, Medical Imaging 2002: Physics of Medical Imaging; (2002) https://doi.org/10.1117/12.465604
Event: Medical Imaging 2002, 2002, San Diego, California, United States

Abstract

Single crystals of mercuric iodide have been studied for many years for nuclear detectors. We have investigated the use of x-ray photoconductive polycrystalline mercuric iodide coatings on amorphous silicon flat panel thin film transistor (TFT) arrays as x-ray detectors for radiographic and fluoroscopic applications in medical imaging. The mercuric iodide coatings were vacuum deposited by Physical Vapor Deposition (PVD). This coating technology is capable of being scaled up to sizes required in common medical imaging applications. Coatings were deposited on 4 inches X 4 inches TFT arrays for imaging performance evaluation and also on conductive-coated glass substrates for measurements of x-ray sensitivity, dark current and image lag. The TFT arrays used included pixel pitch dimensions of both 100 and 139 microns. Coating thickness between 150 microns and 250 microns were tested in the 25 kVp-100 kVp x-ray energy range utilizing exposures typical for both fluoroscopic, and radiographic imaging. X-ray sensitivities measured for the mercuric iodide samples and coated TFT detectors were superior to any published results for competitive materials (up to 7100 ke/mR/pixel for 100 micron pixels). It is believed that this higher sensitivity, can result in fluoroscopic imaging signal levels high enough to overshadow electronic noise. Image lag characteristics appear adequate for fluoroscopic rates. Resolution tests on resolution target phantoms showed that resolution is limited to the Nyquist frequency for the 139 micron pixel detectors. The ability to operate at low voltages gives adequate dark currents for most applications and allows low voltage electronics designs. Mercuric Iodide coated TFT arrays were found to be outstanding candidates for direct digital radiographic detectors for both static and dynamic (fluoroscopic) applications. Their high x-ray sensitivity, high resolution, low dark current, low voltage operation, and good lag characteristics provide a unique combination of desirable imaging performance parameters.

Citation Download Citation

George Zentai, Larry D. Partain, Raisa Pavlyuchkova, Gary F. Virshup, Asaf Zuck, Leonid Melekhov, O. Dagan, Alexander I. Vilensky, and Haim Gilboa "Large-area mercuric iodide x-ray imager", Proc. SPIE 4682, Medical Imaging 2002: Physics of Medical Imaging, (3 May 2002); https://doi.org/10.1117/12.465604

ACCESS THE FULL ARTICLE