Translator Disclaimer
Paper
30 January 2003 Precision continuous high-strength Azimuth track for large telescopes
Author Affiliations +
Abstract
A novel track joint was developed for the azimuth track of the 50-m diameter Large Millimeter Telescope (LMT) now under construction in Mexico at an elevation of 4,600 m. The track, which is 430 mm wide by 230 mm deep, must be flat to within ± 0.3 mm, and the material hardness at least 290 Brinell. This design uses a partial penetration narrow gap groove weld on the top surface of the track and a splice plate welded to the underside of the track. Pre-camber of the joint compensates for weld shrinkage which is small because of the use of the narrow gap groove weld. The residual deviations from flatness are reduced to the required tolerance by adjusting anchor bolts using an optimization procedure. The feasibility of the design with respect to fabrication, strength, fatigue, and alignment was demonstrated by detailed finite element analyses, trial welding and alignment of full scale joints, and testing of the mechanical properties of the joint and adjacent metal.
© (2003) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Joseph Antebi and Frank W. Kan "Precision continuous high-strength Azimuth track for large telescopes", Proc. SPIE 4840, Future Giant Telescopes, (30 January 2003); https://doi.org/10.1117/12.459070
PROCEEDINGS
12 PAGES


SHARE
Advertisement
Advertisement
Back to Top