Paper
2 April 2004 Fabrication of micromachined ceramic thin-film-type pressure sensors for overpressure tolerance and its characteristics
Author Affiliations +
Abstract
This paper describes the fabrication process and characteristics of ceramic thin-film pressure sensors based on Ta-N strain gauges for harsh environment applications. The Ta-N thin-film strain gauges are sputter-deposited on a thermally oxidized micromachined Si diaphragm with buried cavities for overpressure tolerance. The proposed device takes advantage of the good mechanical properties of single-crystalline Si as a diaphragm fabricated by SDB and electrochemical etch-stop technology, and in order to extend the temperature range, it has relatively higher resistance, stability and gauge factor of Ta-N thin-films more than other gauges. The fabricated pressure sensor presents a low temperature coefficient of resistance, high-sensitivity, low nonlinearity and excellent temperature stability. The sensitivity is 1.21-1.097 mV/V•kgf/cm2 in temperature ranges of 25-200°C and a maximum non-linearity is 0.43 %FS.
© (2004) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Gwiy-Sang Chung and Jae-Min Kim "Fabrication of micromachined ceramic thin-film-type pressure sensors for overpressure tolerance and its characteristics", Proc. SPIE 5276, Device and Process Technologies for MEMS, Microelectronics, and Photonics III, (2 April 2004); https://doi.org/10.1117/12.522876
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Thin films

Sensors

Ceramics

Silicon

Annealing

Resistance

Temperature metrology

RELATED CONTENT


Back to Top