Translator Disclaimer
Paper
7 June 2004 400-mW 1060-nm ytterbium-doped fiber DFB laser
Author Affiliations +
Proceedings Volume 5335, Fiber Lasers: Technology, Systems, and Applications; (2004) https://doi.org/10.1117/12.527972
Event: Lasers and Applications in Science and Engineering, 2004, San Jose, Ca, United States
Abstract
We report for the first time, more than 400 mW of output power at 1056.1nm from a distributed feedback (DFB) fiber laser. The DFB fiber laser comprises a simple π-phase-shifted Bragg grating written into a photosensitive ytterbium-doped fiber. The laser operates with a single longitudinal mode at a wavelength defined by the phase shift and the grating period. Without any internal polarisation selection mechanism, the cavity supports orthogonal polarisation modes, which operate simultaneously. The DFB fiber laser was pumped by a 976nm amplified spontaneous emission (ASE) source based on a ytterbium doped jacketed air clad (JAC) fiber pumped by a 915nm multimode laser diode source. An output of 400mW at 1056.1nm was obtained from the output port while 70mW was obtained from the other port, when pumped with 1.5W of 976nm radiation. The total output from the DFB fiber laser was approximately linear with increasing pump power and the overall performance was limited by the available pump power. The spectral characteristics and signal to noise ratio remained similar over the pump power range. The output of the DFB was in single-mode fiber (ie. M2~1).
© (2004) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Christophe A. Codemard, Louise M. B. Hickey, Kuthan Yelen, Daniel B. S. Soh, Rachel Wixey, Mark Coker, Mikhail N. Zervas, and Johan Nilsson "400-mW 1060-nm ytterbium-doped fiber DFB laser", Proc. SPIE 5335, Fiber Lasers: Technology, Systems, and Applications, (7 June 2004); https://doi.org/10.1117/12.527972
PROCEEDINGS
8 PAGES


SHARE
Advertisement
Advertisement
RELATED CONTENT


Back to Top