Paper
28 May 2004 Feasibility studies of ArF chromeless mask (CLM) for sub-80-nm era
Tae-Seung Eom, Chang-Moon Lim, Min Gyu Sung, Seung Chan Moon, Ki Soo Shin
Author Affiliations +
Abstract
In this paper, we discuss feasibility of ArF chromeless mask (CLM) for sub-80nm era. Simulation and experiment are performed in terms of influence of quartz sidewall angle of CLM, process margin for 80nm DRAM cells, and mask polarity such as trench or mesa etc. Mask layouts are optimized through the use of resist patterning simulation for various critical layers of DRAM with trench and mesa type CLM, respectively. Lithography simulation is done by using in-house tool based on diffused aerial image model. SOLID-CTM is also using in order to study the influence of quartz sidewall angle and mask polarity. In the case of mask polarity, mesa type CLM is easier to make in the view of mask-making process, but in view of lithographic performance, trench type CLM is found to be better than mesa type. Quartz sidewall angle of CLM is one of the important factors for lithographic performance. The quartz sidewall angle of CLM gives severe impact on the lithographic performance. As quartz sidewall angle of CLM gets below 90 degrees, image quality, such as process window, aerial image contrast, are further degraded especially in the mesa type CLM. In addition, we also studied influence of phase error, transmittance error etc.
© (2004) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Tae-Seung Eom, Chang-Moon Lim, Min Gyu Sung, Seung Chan Moon, and Ki Soo Shin "Feasibility studies of ArF chromeless mask (CLM) for sub-80-nm era", Proc. SPIE 5377, Optical Microlithography XVII, (28 May 2004); https://doi.org/10.1117/12.536346
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Photomasks

Quartz

Lithography

Transmittance

Optical lithography

Etching

Image quality

RELATED CONTENT

Layer aware source mask target optimization
Proceedings of SPIE (March 15 2016)
Lithography aware overlay metrology target design method
Proceedings of SPIE (March 24 2016)
Computational requirements for OPC
Proceedings of SPIE (March 12 2009)
Patterning strategy for low-K<sub>1</sub> lithography
Proceedings of SPIE (August 20 2004)

Back to Top