You have requested a machine translation of selected content from our databases. This functionality is provided solely for your convenience and is in no way intended to replace human translation. Neither SPIE nor the owners and publishers of the content make, and they explicitly disclaim, any express or implied representations or warranties of any kind, including, without limitation, representations and warranties as to the functionality of the translation feature or the accuracy or completeness of the translations.
Translations are not retained in our system. Your use of this feature and the translations is subject to all use restrictions contained in the Terms and Conditions of Use of the SPIE website.
15 September 2004Low-loss photonic wires and compact ring resonators in silicon-on-insulator
We fabricated single-mode photonic wires, nanophotonic waveguides confining light by total internal reflection. The structures are defined in silicon-on-insulator using 248nm deep UV lithography, a widely adopted technology for CMOS applications. The crystalline silicon core has a thickness of 220nm and a width of up to 600nm. A 1um thick silica layer serves as the lower cladding. We measured the loss of straight waveguides using the Fabry-Perot interference spectrum of the cleaved samples. A 500nm wide waveguide has a loss as low as 2.4dB/cm at 1550nm wavelength. We measured 90 degree bends to have excess losses of about 1dB. Mirror bends perform comparably. We fabricated symmetrically coupled ring and "racetrack" resonators with small radius. Q-factors higher than 3000 are achieved, leading to low add-drop crosstalk, high finesse and low at-resonance insertion loss. By fitting the theoretical model to the experimental results, we extracted parameters such as the coupling ratio, cavity loss and group index. We analyzed the fabrication tolerances allowed for these resonators to be suitable as a building block for WDM filtering components. The allowed deviation on the waveguide widths and gaps for the coupling ratio to be within specification are within the possibilities of the fabrication method. However, a method to tightly control the optical cavity length is needed as the ring's group index is highly dependent on waveguide width.
The alert did not successfully save. Please try again later.
Pieter Dumon, Wim Bogaerts, Joris Van Campenhout, Vincent Wiaux, Johan M.D. Wouters, Stephan Beckx, Roel G. Baets, "Low-loss photonic wires and compact ring resonators in silicon-on-insulator," Proc. SPIE 5450, Photonic Crystal Materials and Nanostructures, (15 September 2004); https://doi.org/10.1117/12.548266