Paper
10 September 2004 Three-dimensional vision using structured light applied to quality control in production line
Louis-Severin Bieri, Jacques Jacot
Author Affiliations +
Abstract
Traditional backlighting vision systems are unable to measure the height dimensions of an object. It can then be more convenient to use a 3D scanner, based for example on the projection of structured light. Despite the high potential of this technique and the growing demand of the industry for performing quality vision control, 3D measurement systems are still often considered as unusual solutions. This proceeding presents our 3D measurement laboratory setup based on the projection of structured light by means of a LCD beamer. This system is intended to be used in automated assembly line. The height information comes from a phase map obtained through temporal phase unwrapping. This phase always contain noise. Part of this noise brings a random phase error. A simple estimator of the random phase error is presented. It gives two parameters to which it is necessary to pay attention in order to predict measurement repeatability and thus to improve it. The estimator is experimentally validated on our setup.
© (2004) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Louis-Severin Bieri and Jacques Jacot "Three-dimensional vision using structured light applied to quality control in production line", Proc. SPIE 5457, Optical Metrology in Production Engineering, (10 September 2004); https://doi.org/10.1117/12.545039
Lens.org Logo
CITATIONS
Cited by 12 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Cameras

Structured light

Error analysis

3D metrology

3D vision

Calibration

Projection systems

Back to Top