Translator Disclaimer
Paper
8 June 2005 Interface strain transfer mechanism and error modification for adhered FBG strain sensor
Author Affiliations +
Proceedings Volume 5851, Fundamental Problems of Optoelectronics and Microelectronics II; (2005) https://doi.org/10.1117/12.634066
Event: Fundamental Problems of Optoelectronics and Microelectronics II, 2004, Khabrovsk, Russian Federation
Abstract
The application of adhered FBG strain sensor is affected by interface strain transfer and error modification. In his paper, firstly, based on the characterstics of forces and damage, the fundamental hupotheses are given, and the general expression of interface transferring mechanism is derived. After that, united form of the characteristic value-λ for the general equation is geven for the multi-layer coatings. Finally, according to the error-modified equation of adhered FBG sensor, the relationships the error rate η against the shear modulus and the thckness of the glue are given. With regard to the glue applied in engineering (thickness is from 4mm to 60mm, shear modulus is from 30MPa to 200MPa), the error rate η is about 5~10%, and the correction coefficient k is about 1.05~1.11. Hence, the error modification must be considered when adhered FBG strain sensors are used in civil engineering.
© (2005) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Jilong Li, Zhi Zhou, and Jinping Ou "Interface strain transfer mechanism and error modification for adhered FBG strain sensor", Proc. SPIE 5851, Fundamental Problems of Optoelectronics and Microelectronics II, (8 June 2005); https://doi.org/10.1117/12.634066
PROCEEDINGS
10 PAGES


SHARE
Advertisement
Advertisement
Back to Top