Paper
13 October 2005 2.5Gbit/s fiber receiver with integrated PIN photodiode in low-cost 0.6μm BiCMOS
Author Affiliations +
Abstract
In resent publications we presented PIN photodiodes with a bandwidth of 600MHz implemented in low-cost 0.6μm BiCMOS technology. A new method to increase the response time of these PIN photodiodes is proposed here. This method was applied to design an optical fiber receiver with a maximum possible data rate of 2.5Gbit/s. In addition to the PIN photodiode attached to a transimpedance amplifier it also includes a decision circuit and a 50Ω output driver. The measured bandwidth of the receiver of 1.90GHz is sufficient for 2.5Gbit/s. At an optical wavelength of 660nm, a sensitivity of -17.0dBm was measured. At a supply voltage of 5V, the power consumption of the complete receiver is 171mW, from which the output driver requires 128mW. The overall chip size is 1154μm times 727μm.
© (2005) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Michael Förtsch and Horst Zimmermann "2.5Gbit/s fiber receiver with integrated PIN photodiode in low-cost 0.6μm BiCMOS", Proc. SPIE 5964, Detectors and Associated Signal Processing II, 596401 (13 October 2005); https://doi.org/10.1117/12.620632
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Receivers

PIN photodiodes

Photodiodes

Optical amplifiers

Optical fibers

Photonic integrated circuits

Doping

RELATED CONTENT

Wide dynamic range optical receiver design
Proceedings of SPIE (November 04 1993)
Comparison of CMOS and BiCMOS optical receiver SoCs
Proceedings of SPIE (April 21 2003)
Monolithic Integration Of InGaAs PIN FET From simple...
Proceedings of SPIE (July 09 1986)
Complete low cost 625Mbit s optical fiber receiver in 0.6µm...
Proceedings of SPIE (September 24 2005)
A 38THz-Ohm OEIC for DVD Applications
Proceedings of SPIE (August 18 2004)

Back to Top