Paper
7 November 2005 Monolithic DFB laser diodes emitting at 785 nm for in situ SER spectroscopy
Martin Maiwald, Götz Erbert, Andreas Klehr, Bernd Sumpf, Hans Wenzel, Heinar Schmidt, Heinz-Detlef Kronfeldt
Author Affiliations +
Abstract
A distributed feedback (DFB) laser diode emitting at 785 nm was used as light source for Raman spectroscopy. An in situ surface enhanced Raman spectroscopic (SERS) sensor was developed to detect polycyclic aromatic hydrocarbons (PAHs) in marine environment at concentration levels down to nmol/l. The DFB diode used in our SERS experiments had an output power of 150 mW at 785 nm and a spectral linewidth of 3 MHz. The wavelength stability of this laser was ± 0.004 nm over 12 hours. A side mode suppression ratio up to 45 dB was determined. For trace detection of chemicals in marine environment, SERS active substrates were employed based on silver colloids encapsulated in a sol-gel derived matrix. The resulting spectra and a limit of detection (LOD) of phenathrene (34 nmol/l) as an example for PAHs in seawater are presented. A concentration of 1 nmol/l of pyrene was detected.
© (2005) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Martin Maiwald, Götz Erbert, Andreas Klehr, Bernd Sumpf, Hans Wenzel, Heinar Schmidt, and Heinz-Detlef Kronfeldt "Monolithic DFB laser diodes emitting at 785 nm for in situ SER spectroscopy", Proc. SPIE 5993, Advanced Environmental, Chemical, and Biological Sensing Technologies III, 599305 (7 November 2005); https://doi.org/10.1117/12.630613
Lens.org Logo
CITATIONS
Cited by 6 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Raman spectroscopy

Surface enhanced Raman spectroscopy

Semiconductor lasers

Sensors

Laser stabilization

Optical filters

Dielectric filters

Back to Top