Design of a prototype primary mirror segment positioning actuator for the Thirty Meter Telescope

Kenneth R. Lorell; Jean-Noël Aubrun; Robert R. Clappier; Scott W. Miller; Mark Sirota

doi:10.1117/12.672917

23 June 2006 Design of a prototype primary mirror segment positioning actuator for the Thirty Meter Telescope

Kenneth R. Lorell, Jean-Noël Aubrun, Robert R. Clappier, Scott W. Miller, Mark Sirota

Proceedings Volume 6267, Ground-based and Airborne Telescopes; 62672T (2006) https://doi.org/10.1117/12.672917
Event: SPIE Astronomical Telescopes + Instrumentation, 2006, Orlando, Florida , United States

Abstract

The Thirty Meter Telescope (TMT) is a collaborative project between the California Institute of Technology (CIT), the University of California (UC), the Association of Universities for Research in Astronomy (AURA), and the Association of Canadian Universities for Research in Astronomy (ACURA). In order for the Thirty Meter Telescope (TMT) to achieve the required optical performance, each of its 738 primary mirror segments must be positioned relative to adjacent segments with nanometer-level accuracy. Three in plane degrees of freedom are controlled via a passive Segment Support Assembly which is described in another paper presented at this conference (paper 6273-45). The remaining three out of plane degrees of freedom, tip, tilt, and piston, are controlled via three actuators for each segment. Because of its size and the shear number of actuators, TMT will require an actuator design, departing from that used on the Keck telescopes, its successful predecessor. Sensitivity to wind loads and structural vibrations, the large dynamic range, low operating power, and extremely reliable operation, all achieved at an affordable unit cost, are the most demanding design requirements. This paper describes a concept that successfully meets the TMT requirements, along with analysis and performance predictions. The actuator concept is based on a prototype actuator developed for the California Extremely Large Telescope (CELT) project. It relies on techniques that achieve the required accuracy while providing a substantial amount of vibration attenuation and damping. A development plan consisting of a series of prototype actuators is envisioned to verify cost, reliability, and performance before mass production is initiated. The first prototype (P₁) of this development plan is now being built and should complete initial testing by the end of 2^nd QTR 06.

Citation Download Citation

Kenneth R. Lorell, Jean-Noël Aubrun, Robert R. Clappier, Scott W. Miller, and Mark Sirota "Design of a prototype primary mirror segment positioning actuator for the Thirty Meter Telescope", Proc. SPIE 6267, Ground-based and Airborne Telescopes, 62672T (23 June 2006); https://doi.org/10.1117/12.672917

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available