Paper
21 June 2006 Single point optical calibration of accelerometers at NIST
Bev Payne
Author Affiliations +
Proceedings Volume 6345, Seventh International Conference on Vibration Measurements by Laser Techniques: Advances and Applications; 634504 (2006) https://doi.org/10.1117/12.693100
Event: Seventh International Conference on Vibration Measurements by Laser Techniques: Advances and Applications, 2006, Ancona, Italy
Abstract
Typical accelerometer calibrations by laser interferometer are performed by measuring displacement at three places on the shaker table. Each of these measurements, made along the perimeter of the accelerometer, requires repositioning and realigning of the interferometer. This is done to approximate the actual displacement of the accelerometer. Using a dual-coil shaker with a small moving element and two coaxially-located and rigidly-attached mounting tables allows placing the accelerometer on one table and measuring displacement directly on the center axis of the second table. This was found to work effectively at lower frequencies, up to about 5 kHz, with mounting tables of conventional materials such as stainless steel. However, for higher frequencies the use of steel results in unwanted relative motion between the two mounting tables. Mounting tables of beryllium with nickel coating have been used at NIST to overcome this difficulty. This paper shows the calibration results of single point, on-axis measurements, using fringe counting and sine-approximation methods. The results compare favorably with three point measurements made by fringe disappearance using a conventional piezo-electric shaker at frequencies up to 15 kHz.
© (2006) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Bev Payne "Single point optical calibration of accelerometers at NIST", Proc. SPIE 6345, Seventh International Conference on Vibration Measurements by Laser Techniques: Advances and Applications, 634504 (21 June 2006); https://doi.org/10.1117/12.693100
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Calibration

Beryllium

Interferometers

Optical calibration

Mirrors

Sensors

Nickel

Back to Top