Paper
27 April 2007 Performance evaluation of a new type of jetting dispenser using piezoelectric actuator
Min-Kyu Choi, Bo-Young Yun, Quoc-Hung Nguyen, Seung-Bok Choi, Sung-Min Hong
Author Affiliations +
Abstract
This paper presents a new type of jetting dispenser featuring piezoelectric actuator in order to achieve high flow rate and small dot sizes in semiconductor packaging processes. After describing structural components of the dispensing mechanism and the operating principle, a dynamic modeling is undertaken by considering the behavior of the piezostack, hydraulic magnification, dispensing needle and adhesive fluid. In the modeling, fluid models for adhesive fluid and hydraulic magnification are derived with a dumped parameter method. The governing equation of motion is then derived by integrating the fluid models with structural model. Subsequently, the dynamic behavior of the dispenser and its dispensing amount are investigated by applying several types of square wave driving voltage input and design parameter values are determined.
© (2007) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Min-Kyu Choi, Bo-Young Yun, Quoc-Hung Nguyen, Seung-Bok Choi, and Sung-Min Hong "Performance evaluation of a new type of jetting dispenser using piezoelectric actuator", Proc. SPIE 6525, Active and Passive Smart Structures and Integrated Systems 2007, 652522 (27 April 2007); https://doi.org/10.1117/12.715161
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Actuators

Adhesives

Fluid dynamics

Motion models

Microfluidics

Semiconductors

Picosecond phenomena

Back to Top