Paper
10 May 2007 Resizing methodology for CMOS analog circuits
Timothée Levi, Jean Tomas, Noëlle Lewis, Pascal Fouillat
Author Affiliations +
Proceedings Volume 6590, VLSI Circuits and Systems III; 65900W (2007) https://doi.org/10.1117/12.721871
Event: Microtechnologies for the New Millennium, 2007, Maspalomas, Gran Canaria, Spain
Abstract
This paper proposes a CMOS resizing methodology for analog circuits during a technology migration. The scaling rules aim to be easy to apply and are based on the simplest MOS transistor model. The principle is to transpose one circuit topology from one technology to another, while keeping the main figures of merit, and the issue is to quickly calculate the new transistor dimensions. Furthermore, when the target technology has smaller minimum length, we expect to obtain a decrease of area. This methodology is applied to both linear and non-linear examples: an OTA and a ring oscillator. The results are compared on three CMOS processes whose minimum length is 0.8 μm, 0.35 μm, 0.25 μm.
© (2007) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Timothée Levi, Jean Tomas, Noëlle Lewis, and Pascal Fouillat "Resizing methodology for CMOS analog circuits", Proc. SPIE 6590, VLSI Circuits and Systems III, 65900W (10 May 2007); https://doi.org/10.1117/12.721871
Lens.org Logo
CITATIONS
Cited by 1 scholarly publication.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Transistors

Analog electronics

Oscillators

CMOS technology

Capacitance

Molybdenum

Systems modeling

RELATED CONTENT

Analysis of 1/f noise in CMOS APS
Proceedings of SPIE (May 15 2000)
Ring oscillator behavior after oxide breakdown
Proceedings of SPIE (June 30 2005)
A 6 18.5 GHz dynamic frequency divider in 0.25µm SOI...
Proceedings of SPIE (December 21 2007)
Design of high speed burst mode clock and data recovery...
Proceedings of SPIE (October 13 2005)

Back to Top