Translator Disclaimer
Paper
2 July 2007 Active vibration control using fiber Bragg grating sensors and piezoelectric actuators in co-located configuration
Author Affiliations +
Proceedings Volume 6619, Third European Workshop on Optical Fibre Sensors; 661940 (2007) https://doi.org/10.1117/12.738797
Event: Third European Workshop on Optical Fibre Sensors, 2007, Napoli, Italy
Abstract
In this paper, the feasibility of an active vibration control scheme using Fiber Bragg Grating (FBG) sensors and piezoelectric (PZT) actuators for vibration suppression of an aluminum plate is investigated. Four FBGs have been bonded to the structure below the same number of PZT actuators in co-located configuration. A Proportional-Derivative controller has been used to generate the command signals required to drive the actuators. Preliminary results from "closed loop" configuration tests are reported showing up to 17 dB of noise reduction at 80 Hz.
© (2007) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
C. Ambrosino, G. Diodati, A. Laudati, A. Gianvito, A. Concilio, R. Sorrentino, G. Breglio, A. Cutolo, and A. Cusano "Active vibration control using fiber Bragg grating sensors and piezoelectric actuators in co-located configuration", Proc. SPIE 6619, Third European Workshop on Optical Fibre Sensors, 661940 (2 July 2007); https://doi.org/10.1117/12.738797
PROCEEDINGS
4 PAGES


SHARE
Advertisement
Advertisement
Back to Top