Translator Disclaimer
Paper
31 December 2008 Workpiece angle measurement based on Hough transform
Author Affiliations +
Proceedings Volume 7130, Fourth International Symposium on Precision Mechanical Measurements; 71303W (2008) https://doi.org/10.1117/12.819699
Event: Fourth International Symposium on Precision Mechanical Measurements, 2008, Anhui, China
Abstract
To overcome the difficulty in the non-contact angle measurement especially for large-scaled workpieces, the paper presents a new angle measurement method based on Hough transform. The realization process of the method consists of workpiece image acquisition & preprocessing and angle measurement. With the preprocessing one can obtain an ideal binarized edge image of the workpiece image. The angle measurement is then carried out by employing the classical Hough transform. Except the discussion of measurement principle, both practical examples and simulated experiments are introduced to demonstrate the performance of the method proposed in the paper. The experiment results indicate that this method can be applied to measure the workpiece angle under many occasions and can achieve the aim of the non-contact angle measurement. At the same time, it does still possess great advantages in terms of reliability and noise rejection capability.
© (2008) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Fuzhong Bai, Changhui Rao, and Zhen Liu "Workpiece angle measurement based on Hough transform", Proc. SPIE 7130, Fourth International Symposium on Precision Mechanical Measurements, 71303W (31 December 2008); https://doi.org/10.1117/12.819699
PROCEEDINGS
6 PAGES


SHARE
Advertisement
Advertisement
RELATED CONTENT

Weld quality assessment using an edge detection algorithm
Proceedings of SPIE (April 14 2010)
K AVE + GNN + Sobel = an effective, highly...
Proceedings of SPIE (September 19 1997)
New fast Hough transform
Proceedings of SPIE (September 25 1998)

Back to Top