Primary mirror dynamic disturbance models for TMT: vibration and wind

Douglas G. MacMynowski; M. Mark Colavita; Warren Skidmore; Konstantinos Vogiatzis

doi:10.1117/12.857395

9 August 2010 Primary mirror dynamic disturbance models for TMT: vibration and wind

Douglas G. MacMynowski, M. Mark Colavita, Warren Skidmore, Konstantinos Vogiatzis

Proceedings Volume 7738, Modeling, Systems Engineering, and Project Management for Astronomy IV; 77380E (2010) https://doi.org/10.1117/12.857395
Event: SPIE Astronomical Telescopes + Instrumentation, 2010, San Diego, California, United States

Abstract

The principal dynamic disturbances acting on a telescope segmented primary mirror are unsteady wind pressure (turbulence) and narrowband vibration from rotating equipment. Understanding these disturbances is essential for the design of the segment support assembly (SSA), segment actuators, and primary mirror control system (M1CS). The wind disturbance is relatively low frequency, and is partially compensated by M1CS; the response depends on the control bandwidth and the quasi-static stiffness of the actuator and SSA. Equipment vibration is at frequencies higher than the M1CS bandwidth; the response depends on segment damping, and the proximity of segment support resonances to dominant vibration tones. We present here both disturbance models and parametric response. Wind modeling is informed by CFD and based on propagation of a von Karman pressure screen. The vibration model is informed by analysis of accelerometer and adaptive optics data from Keck. This information is extrapolated to TMT and applied to the telescope structural model to understand the response dependence on actuator design parameters in particular. Whether the vibration response or the wind response is larger depends on these design choices; "soft" (e.g. voice-coil) actuators provide better vibration reduction but require high servo bandwidth for wind rejection, while "hard" (e.g. piezo-electric) actuators provide good wind rejection but require damping to avoid excessive vibration transmission to the primary mirror segments. The results for both nominal and worst-case disturbances and design parameters are incorporated into the TMT actuator performance assessment.

Citation Download Citation

Douglas G. MacMynowski, M. Mark Colavita, Warren Skidmore, and Konstantinos Vogiatzis "Primary mirror dynamic disturbance models for TMT: vibration and wind", Proc. SPIE 7738, Modeling, Systems Engineering, and Project Management for Astronomy IV, 77380E (9 August 2010); https://doi.org/10.1117/12.857395

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available