Paper
1 September 2010 X-ray detection method for the direct-conversion plasma detector
Author Affiliations +
Abstract
In this study 2-dimensional plasma simulation code was used to find a new approach of x-ray detection method with PDP-like geometry and condition. A conventional PDP geometry consisted of three electrodes was selected and Ne-Xe composition gas was filled the cell-gap. Depending on incident X-ray energy, the number of charges generated within the cell-gap could be different. For the charge amplification and collection of charges two consecutive ac pulses were applied to scan and address electrodes. The increased charges were collected on the positive-bias address electrode at the rear panel. Two parameters, such as amplitude of collected current and formation delay of collected current, were calculated and compared. The formation delay showed more accurate relationship than the collected current amplitude.
© (2010) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Jungwon Kang, Hyungsup Shin, Sangjun Lee, Kisung Lee, and Hakjae Lee "X-ray detection method for the direct-conversion plasma detector", Proc. SPIE 7805, Hard X-Ray, Gamma-Ray, and Neutron Detector Physics XII, 78051D (1 September 2010); https://doi.org/10.1117/12.862497
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Electrodes

X-rays

Sensors

X-ray detectors

Plasma display panels

Plasma

Dielectrics

RELATED CONTENT

CdZnTe strip detectors for high-energy x-ray astronomy
Proceedings of SPIE (July 19 1996)
Design and performance of the HEXIS CZT detector module
Proceedings of SPIE (January 10 2003)
Charge cloud asymmetry in detectors with biased MCPs
Proceedings of SPIE (January 25 2002)
Design and calibration of the GOES 8 solar x ray...
Proceedings of SPIE (October 18 1996)
Position-sensitive CZT detector module
Proceedings of SPIE (July 01 1998)

Back to Top