Translator Disclaimer
23 March 2012 Optimizing EUV mask blank cleaning processes using the Lasertec M7360
Author Affiliations +
EUV lithography is considered the most promising lithography solution for the 16 nm node and beyond. As EUV light is strongly absorbed by all known materials, reflective optics are used instead of conventional transmittance optics applied to ArF and KrF lithography. The EUV mask must also need be reflective. It typically consists of a Ta-based absorber layer, Ru capping layer, Si/Mo multilayer on a low thermal expansion material (LTEM) substrate with a backside Cr-based metal coating. Because of the strong absorbance of the EUV light, a pellicle is not practical. Therefore, EUV masks must be cleaned more frequently to maintain the necessary cleanliness. This poses numerous unique challenges in cleaning processes. For example, the EUV mask integrity, including critical dimension (CD), EUV reflectivity, and absorber thickness must be kept intact during multiple cleanings throughout the mask's lifetime. Requirements of defect size for the cleaning, furthermore, are becoming tighter as semiconductor circuit design rules get smaller. According to the International Technology Roadmap For Semiconductors (ITRS), the smallest defect size that must be removed is 23 nm for the 18 nm NAND Flash node in 2013. In addition to defects on the frontside, defects on a backside also need to be minimized since they might lead overlay error due to local distortions of EUV masks on an electrostatic chuck. This paper focuses on evaluations of cleaning performances using the Lasertec M1350 and M7360 blank inspection system, which has a 71 nm and 43 nm sensitivity. The 43nm is the current best sensitivity while keeping a >90% defect capture rate. First, the cleaning performance using the standard process has been investigated. We found a mitigation of adders was a key challenge for the EUV mask cleaning. The primary source of the adders was also identified as pits. Secondly, the megasonic cleaning process has been optimized to mitigate the adders. We could successfully reduce the adders by 30%. Thirdly, to confirm the entire cleaning process, a backside cleaning process combined with frontside cleaning was investigated, demonstrating that the backsides of the EUV mask blanks could be cleaned without additional impact on frontside defectivity.
© (2012) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Takeya Shimomura, Arun John Kadaksham, Matt House, Andy Ma, and Frank Goodwin "Optimizing EUV mask blank cleaning processes using the Lasertec M7360", Proc. SPIE 8322, Extreme Ultraviolet (EUV) Lithography III, 83221Y (23 March 2012);


Development status of EUVL mask blanks in AGC
Proceedings of SPIE (October 30 2007)
EUV mask defects and their removal
Proceedings of SPIE (April 16 2012)
A lifetime study of EUV masks
Proceedings of SPIE (September 24 2010)
Electron beam inspection of 16nm HP node EUV masks
Proceedings of SPIE (November 08 2012)

Back to Top