Development and performance of a gamma-ray imaging detector

J. L. Gálvez; M. Hernanz; J. M. Álvarez; M. La Torre; L. Álvarez; D. Karelin; M. Lozano; G. Pellegrini; M. Ullán; E. Cabruja; R. Martínez; M. Chmeissani; C. Puigdengoles

doi:10.1117/12.925979

Translator Disclaimer

17 September 2012 Development and performance of a gamma-ray imaging detector

J. L. Gálvez, M. Hernanz, J. M. Álvarez, M. La Torre, L. Álvarez, D. Karelin, M. Lozano, G. Pellegrini, M. Ullán, E. Cabruja, R. Martínez, M. Chmeissani, C. Puigdengoles

Author Affiliations +

Proceedings Volume 8443, Space Telescopes and Instrumentation 2012: Ultraviolet to Gamma Ray; 844336 (2012) https://doi.org/10.1117/12.925979
Event: SPIE Astronomical Telescopes + Instrumentation, 2012, Amsterdam, Netherlands

Abstract

In the last few years we have been working on feasibility studies of future instruments in the gamma-ray range, from several keV up to a few MeV. The innovative concept of focusing gamma-ray telescopes in this energy range, should allow reaching unprecedented sensitivities and angular resolution, thanks to the decoupling of collecting area and detector volume. High sensitivities are essential to perform detailed studies of cosmic explosions and cosmic accelerators, e.g., Supernovae, Classical Novae, Supernova Remnants (SNRs), Gamma-Ray Bursts (GRBs), Pulsars, Active Galactic Nuclei (AGN). In order to achieve the needed performance, a gamma-ray imaging detector with mm spatial resolution and large enough efficiency is required. In order to fulfill the combined requirement of high detection efficiency with good spatial and energy resolution, an initial prototype of a gamma-ray imaging detector based on CdTe pixel detectors is being developed. It consists of a stack of several layers of CdTe detectors with increasing thickness, in order to enhance the gamma-ray absorption in the Compton regime. A CdTe module detector lies in a 11 x 11 pixel detector with a pixel pitch of 1mm attached to the readout chip. Each pixel is bump bonded to a fan-out board made of alumina (Al₂O₃) substrate and routed to the corresponding input channel of the readout ASIC to measure pixel position and pulse height for each incident gamma-ray photon. We will report the main features of the gamma-ray imaging detector performance such as the energy resolution for a set of radiation sources at different operating temperatures.

Citation Download Citation

J. L. Gálvez, M. Hernanz, J. M. Álvarez, M. La Torre, L. Álvarez, D. Karelin, M. Lozano, G. Pellegrini, M. Ullán, E. Cabruja, R. Martínez, M. Chmeissani, and C. Puigdengoles "Development and performance of a gamma-ray imaging detector", Proc. SPIE 8443, Space Telescopes and Instrumentation 2012: Ultraviolet to Gamma Ray, 844336 (17 September 2012); https://doi.org/10.1117/12.925979

ACCESS THE FULL ARTICLE