Hermes: the engineering challenges

Jurek Brzeski; Luke Gers; Greg Smith; Nicholas Staszak

doi:10.1117/12.924635

Translator Disclaimer

24 September 2012 Hermes: the engineering challenges

Jurek Brzeski, Luke Gers, Greg Smith, Nicholas Staszak

Author Affiliations +

Proceedings Volume 8446, Ground-based and Airborne Instrumentation for Astronomy IV; 84464N (2012) https://doi.org/10.1117/12.924635
Event: SPIE Astronomical Telescopes + Instrumentation, 2012, Amsterdam, Netherlands

Abstract

The Australian Astronomical Observatory is building a 4-channel VPH-grating High Efficiency and Resolution Multi Element Spectrograph (HERMES) for the 3.9 meter Anglo-Australian Telescope (AAT). HERMES will provide a nominal spectral resolving power of 28,000 for Galactic Archaeology with an optional high-resolution mode of 45,000 with the use of a slit mask. HERMES is fed by a fibre positioning robot called 2dF at the telescope prime focus. There are a total of 784 science fibres, which interface with the spectrograph via two separate slit body assemblies, each comprising of 392 science fibers. The slit defines the spectral lines of 392 fibres on the detector. The width of the detector determines the spectral bandwidth and the detector height determines the fibre to fibre spacing or cross talk. Tolerances that follow from this are all in the 10 micrometer range. The slit relay optics must contribute negligibly to the overall image quality budget and uniformly illuminate the spectrograph exit pupil. The latter requirement effectively requires that the relay optics provide a telecentric input at the collimator entrance slit. As a result it is critical to align the optical components to extreme precision required by the optical design. This paper discusses the engineering challenges of designing, optimising, tolerancing and manufacturing of very precise mechanical components for housing optics and the design of low cost of jigs and fixtures for alignment and assembly of the optics.

Citation Download Citation

Jurek Brzeski, Luke Gers, Greg Smith, and Nicholas Staszak "Hermes: the engineering challenges", Proc. SPIE 8446, Ground-based and Airborne Instrumentation for Astronomy IV, 84464N (24 September 2012); https://doi.org/10.1117/12.924635

ACCESS THE FULL ARTICLE