Paper
15 October 2012 Investigation of various clean room gloves for cleanliness
Lynette Lobmeyer, Mike Pirkey
Author Affiliations +
Abstract
The donning of gloves is an essential handling requirement for minimizing aerospace hardware contamination. . Glove manufacturers frequently tout particle cleanliness, aqueous extractables, and pin holes in their literature. However, t comfort, dexterity, the level of non-volatile residue, and other characteristics are also important characteristics to consider when dealing with contamination sensitive, high-value hardware. In this paper, Ball Aerospace and Technologies (BATC) reports on its s investigation of several readily available gloves for use in the aerospace manufacturing environment and has developed a method of selection, testing, and analysis to ensure that gloves donned are ready for service. The testing method used do not necessarily comply any with any industry standards. The original tests fell into several categories. One of these was a non-volatile residue (NVR) test which examined contamination on the surface of the glove. A number of lots from several manufacturers were evaluated which provided insights into the cleanliness levels of gloves from potential. This has allowed us to track the lot to lot variability of the cleanliness level of gloves we receive from approved vendors.
© (2012) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Lynette Lobmeyer and Mike Pirkey "Investigation of various clean room gloves for cleanliness", Proc. SPIE 8492, Optical System Contamination: Effects, Measurements, and Control 2012, 84920K (15 October 2012); https://doi.org/10.1117/12.966857
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Manufacturing

Aerospace engineering

Latex

Contamination

Resistance

Particles

Analytical research

RELATED CONTENT

Advanced edge resist remover for photomask
Proceedings of SPIE (December 06 2004)
Characteristics of Photonis 6-um pore microchannel plates
Proceedings of SPIE (December 13 2000)
Standards for contamination control
Proceedings of SPIE (October 15 2004)

Back to Top