Measurement of the 1/f noise of lateral actuated MEMS with sidewall piezoresistors

Vladimir Stavrov; Franz Kohl; Thilo Sauter; Philip Philipov

doi:10.1117/12.2017427

17 May 2013 Measurement of the 1/f noise of lateral actuated MEMS with sidewall piezoresistors

Vladimir Stavrov, Franz Kohl, Thilo Sauter, Philip Philipov

Proceedings Volume 8763, Smart Sensors, Actuators, and MEMS VI; 87632S (2013) https://doi.org/10.1117/12.2017427
Event: SPIE Microtechnologies, 2013, Grenoble, France

Abstract

Measurement of the 1/f noise of MEMS devices with sidewall embedded piezoresistors, prototyped for the current study, are described in the present paper. A modified sample conditioning and pre-amplification setup was employed and the complete arrangement was kept at 30°C. The 1/f and the 1/Δf noise signals are fully correlated as the underlying mechanism is the same for both phenomena. The bias voltage of each resistor ranges from zero to V_pp and the device currents contain 1/f noise due to the DC bias in conjunction with conductivity fluctuations. Accordingly, the AC bias results in 1/Δf noise centred about the frequency of the sinusoidal. The spectrally resolved analysis of the 1/f and down-converted 1/Δf noise signals was then established with two instances of a digital lock-in amplifier capable of mHz operation. As both lock-in amplifiers have been locked to a common reference signal, the spectral analyser keeps any correlation between the two channels. Measurements of the current noise were done over the frequency range 0.0625 Hz to 2.048 kHz and measurement resolution of about 10^-18 V²/Hz is determined by the selected correlator averaging period in conjunction with the total noise of the instrumentation channels. For a direct comparison with metal-film resistor technology, sidewall piezoresistors have been replaced by 1 kΩ metal-film resistors for dedicated measurements. The crossover of the 1/f noise of a full bridge of piezoresistors and their thermal noise will appear below 10 Hz for a bias voltage smaller than 1V. This is, to our best knowledge, among the best 1/f noise performances for piezoresistors.

Citation Download Citation

Vladimir Stavrov, Franz Kohl, Thilo Sauter, and Philip Philipov "Measurement of the 1/f noise of lateral actuated MEMS with sidewall piezoresistors", Proc. SPIE 8763, Smart Sensors, Actuators, and MEMS VI, 87632S (17 May 2013); https://doi.org/10.1117/12.2017427

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available