Paper
20 May 2013 Pressure sensor based on an all-fiber Fabry-Pérot interferometer for different gaseous environments
Author Affiliations +
Proceedings Volume 8794, Fifth European Workshop on Optical Fibre Sensors; 87940H (2013) https://doi.org/10.1117/12.2025394
Event: Fifth European Workshop on Optical Fibre Sensors, 2013, Krakow, Poland
Abstract
This work describes an all-fiber Fabry-Pérot interferometer (FFPI) that is sensitive to gas pressure variations. The geometry of the air cavity consists on splicing a small section of silica rod with a large offset in between two singlemode fibers. It is shown that the FFPI sensor is sensitive to gas pressure variation and when submitted to different gaseous environments, namely carbon dioxide, nitrogen and oxygen, it presented different sensitivities of 6.2, 4.1 and 3.6 nm/MPa, respectively. This result is obtained due to refractive index difference between gases. The refractive index change on nitrogen environment by means of the gas pressure variation resulted in a sensitivity of 1526 nm/RIU. The response of the sensing device to temperature in air was also determined and a sensitivity of -14 pm/°C was attained.
© (2013) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Susana Silva, L. Coelho, and O. Frazão "Pressure sensor based on an all-fiber Fabry-Pérot interferometer for different gaseous environments", Proc. SPIE 8794, Fifth European Workshop on Optical Fibre Sensors, 87940H (20 May 2013); https://doi.org/10.1117/12.2025394
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Single mode fibers

Sensors

Silica

Interferometers

Oxygen

Environmental sensing

Head

Back to Top