Paper
16 September 2014 Investigation on resistive switching characteristics of ZnO thin film
Min Wei, Fan Yang, Chunfu Li, Hong Deng, Guangjun Wen
Author Affiliations +
Abstract
Recently resistive switching (RS) based on ZnO thin film has attracted considerable attention since ZnO with doping can improve the switching ratio and device performance. In this work, Cu/ZnO/AZO (Al-doped ZnO) and Cu/ZnO:Cu (Cudoped ZnO) /AZO structures were fabricated for RS, using AZO as bottom electrodes due to its lattice matching with ZnO, and metal Cu was deposited as the top electrodes. The current-voltage (I-V) characteristics of these RS devices using different doped ZnO thin films as a dielectric layer were analyzed and compared. The results demonstrated that ZnO:Cu RS had a higher switching ratio and a larger range of setup and reset voltage than ZnO RS. In addition, we also found that the high resistance state(HRS)and the low resistance state (LRS) were accordance with space charge limited current (SCLC) and Ohm’s law respectively. In addition, the effect on RS performance by the top electrode was investigated by depositing top electrode with different sizes and annealing treatment, and the results indicate that the RS phenomenon occurred in these Cu/ZnO:Cu/AZO structure devices is caused by bulk effect and interfacial effect synthetically.
© (2014) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Min Wei, Fan Yang, Chunfu Li, Hong Deng, and Guangjun Wen "Investigation on resistive switching characteristics of ZnO thin film", Proc. SPIE 9174, Nanoepitaxy: Materials and Devices VI, 91740T (16 September 2014); https://doi.org/10.1117/12.2064914
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Remote sensing

Zinc oxide

Thin films

Switching

Lawrencium

Electrodes

Resistance

Back to Top