Paper
12 September 2014 WDM-PON network simulation with different implementation of optical amplifier in the line
Author Affiliations +
Abstract
This article is dealing with simulation of deployment of different optical amplifier types in different positions (power amplifier, in-line amplifier, preamplifier) in the WDM-PON network. For simulation available bit rates per chanell were taken in to account, specifically 125 Mbps, 1.25 Gbps and 2.5 Gbps. Optical amplifiers implementation than has influence on possible transmission distance for WDM-PON network. In simulated topology parameters as bit error ratio, attenuation, Q-factor, OSNR, etc. were observed. The whole designed WDM-PON network topology was based on real device Ericsson-LG EAST1100 available on the market. Necessary parameters and data for simulation were obtained from datasheets and real measurements so that the simulation resemble to the real measured results as much as possible.
© (2014) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Jan Latal, Petr Koudelka, Petr Siska, Jan Vitasek, and Vladimir Vasinek "WDM-PON network simulation with different implementation of optical amplifier in the line", Proc. SPIE 9193, Novel Optical Systems Design and Optimization XVII, 919318 (12 September 2014); https://doi.org/10.1117/12.2060112
Lens.org Logo
CITATIONS
Cited by 2 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Optical amplifiers

WDM-PON

Raman spectroscopy

Signal to noise ratio

Attenuators

Fiber amplifiers

Networks

Back to Top