Paper
22 June 2015 Monitoring deformations of industrial objects using optical-electronic autoreflection system
Igor A. Konyakhin, Maksim A. Kleshchenok
Author Affiliations +
Abstract
Nowadays, optical-electronics measuring instruments for control the linear deformations in the monitoring industrial constructions (turbines, dams, booms, bases plates, walls, etc) are used effectively. Autocollimating and auto-reflecting schemes are two main basic of such systems. The autocollimating system has larger sensitive than auto reflecting ones. However, the auto reflecting system is more effective for using IR LED as a source and using CCD matrix as a photo-receiver. In addition, the auto-reflecting system has larger working distance than autocollimating system. The experimental test-bed of auto-reflecting system for alignment control was realized. Parameters of a system are the following: IR LED L2656-03 with power 9 mW as sources of radiation; the focal length of autocollimators objective is 250 mm, the matrix change couple devise as photo-receiver with dimension of pixel 2.2μm. The experimental error of this system is 0,007 mm on a working distance of 0.5 m and 0.06 mm on a distance of 8 m.
© (2015) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Igor A. Konyakhin and Maksim A. Kleshchenok "Monitoring deformations of industrial objects using optical-electronic autoreflection system", Proc. SPIE 9525, Optical Measurement Systems for Industrial Inspection IX, 95251W (22 June 2015); https://doi.org/10.1117/12.2183604
Lens.org Logo
CITATIONS
Cited by 2 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Control systems

Charge-coupled devices

Infrared radiation

Light emitting diodes

Prisms

Autocollimators

Infrared imaging

RELATED CONTENT


Back to Top