Proceedings Article | 1 April 1991
Proc. SPIE. 1358, 19th Intl Congress on High-Speed Photography and Photonics
KEYWORDS: Cameras, Sensors, Glasses, Microchannel plates, X-rays, Picosecond phenomena, X-ray imaging, Laser glasses, X-ray detectors, Laser systems engineering
The glass laser Inertial Confinement Program in the USA has made significant achievements in laser compression of
capsules filled with thermonuclear fuel. To achieve a high degree of implosion, a symmetric irradiation is essential
and is achieved by a large number of smoothed laser beams directly impinging on a target or by indirect drive(1 '2)•
The key diagnostic used to monitor arid adjust the symmetry of indirect drive at LLNL and to some extent direct drive
at LLE is time resolved two dimensional x-ray imaging, which allows the experimentalists to observe in emission
the symmetry of the imploding shell during the implosion phase, and the size and shape of the hot fuel in the
stagnation phase. An example of a sequence of 14 images graphically illustrating a direct drive implosion with a
well balanced direct drive laser system is shown in Fig. 1.
The need for this capability has focussed the high speed photography effort at LLNL and LLE. In the last several
years, demonstrated that 80 Ps x-ray gating with 30 mm detector plane resolution is routine, and 35 ps x-ray gating
has been achieved and will soon be in routine use soon.
Electro optic tubes can achieve x-ray gating but the limited spatial and temporal resolution(3' 4), caused us to focus
our effort on the gating of microchannelpiate (MCP) proximity focussed x-ray detectors. The only significant
disadvantage of the gating MCP's over electro-optical tubes is that many images on exactly the same line of sight
cannot be achieved. However, multiple images with gated MCP's can be obtained along the lines of sight which are
insignificantly different from each other, with spatial and temporal resolution that are more than adequate. Most
importantly, gated MCP detectors are sufficiently practical that several of them are in routine use on large laser
systems such as the Nova glass laser at LLNL and the Omega glass laser at LLE.
In this paper we report on several of the technical advances made at LLNL in the gating of MCP x-ray detectors over
the past two years, and show typical results obtained from implosions.
The essential features of a gated MCP detector are shown in Fig. 2. A pulsed voltage (typically 1 kV, 100 psec) is
applied across a MCP. The voltage is applied by gold conducting layers on the MCP, which form a microstrip line
with the glass of the MCP being the dielectric(5). While the voltage is applied the photo electrons resulting from xray
photons incident on the coated surface of the MCP are amplified with typically i03 gain. Because the gain is
non-linear with the applied voltage, (subject to consideration on the electron transit line in the MCP, Section IV)
there can be narrowing of the 'optical' gate with respect to the electrical gate. This relaxes the pulse voltage
requirement for the MCP, to FWHM -100 psec, and voltages of typically 1 kV into typically 25W(6).
In section II we discuss the novel approach we use for the generation of the electrical pulses required for the gated
MCP cameras. The spatial resolution and the factors affecting it are described in Section III. We discuss the
temporal resolution of the MCP detectors in Section IV, and in Section V we discuss the configuration of microstrip
coating on MCP detectors we have used and some typical results from laser driven implosions. Off line tests
showing ultra font gating are described in section VI.
