Paper
22 October 1985 Design Aspects Of The University Of Texas 7.6M Telescope - Part II
Frank B. Ray
Author Affiliations +
Proceedings Volume 0542, Optical Fabrication & Testing Workshop; (1985) https://doi.org/10.1117/12.948160
Event: 1985 Albuquerque Conferences on Optics, 1985, Albuquerque, United States
Abstract
To help gain an engineering overview of the efficacy of a low bandwidth figure control or "tuning" system, the Aerospace Corporation, during a review of the 7.6m telescope design, produced a short 16mm film of a simulation designed by Dr. R. Hefner of Aerospace. In this design, the mirror is derived from a blank proposed by the Corning Glass Works, only 5 inches thick, of ULE material. An oscillating point load is placed at a point near the edge of the mirror, half-way between two of the collimating points. Two stages of control are depicted, in quasi-real time, with a clock display inculded. The first is rate damping at the 14 controlled points. The second is based on direct output feed-back of position information derived from the controlled points. A point spread function displays the energy concentration improvement gained by utilizing such figure control methods. Although rate damping can give a measure of improvement, it is clear from this single point case that to obviate the effects of all potentially degrading external forces, direct output feedback is the more desirable approach.
© (1985) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Frank B. Ray "Design Aspects Of The University Of Texas 7.6M Telescope - Part II", Proc. SPIE 0542, Optical Fabrication & Testing Workshop, (22 October 1985); https://doi.org/10.1117/12.948160
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Aerospace engineering

Optical instrument design

Mirrors

Telescopes

Clocks

Control systems

Control systems design

RELATED CONTENT

San Pedro Martir Telescope: Mexican design endeavor
Proceedings of SPIE (August 08 2016)
The ESO's ELT construction status
Proceedings of SPIE (July 06 2018)
Dynamic aspects of segmented mirror position control
Proceedings of SPIE (May 30 2006)
Dynamic analysis of the active control system for the CGST
Proceedings of SPIE (September 25 2012)

Back to Top