PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.
After gathering spectrophotometer data from the 6.5m primary mirror at the MMT Observatory (MMT) for over ten years, the MMT has developed a soap and water wash procedure that effectively removes contaminates from the surface of the mirror without damaging the bare aluminum coating. While the in-situ soap and water wash requires a small amount of telescope downtime, these washes are still scheduled to take place every six months. The frequency of the washing was selected to keep the mirror performance as close to a fresh coating as possible throughout the year and to extend the recoating interval without allowing the reflectivity degrading more than 3% from a fresh coating. After being in service for almost two years, the spectrophotometer measurements indicate the 2016 primary mirror coating is on-track to maintain the specified reflectance for five years. This paper outlines the soap and water wash procedure developed for the MMT primary mirror and presents spectrophotometer data throughout the life of the 2005 and the 2016 mirror coatings.
Ricardo Ortiz,Joseph T. Williams, andWilliam Goble
"Lessons learned from wet washing the 6.5m MMT primary mirror in-situ", Proc. SPIE 10700, Ground-based and Airborne Telescopes VII, 1070004 (6 July 2018); https://doi.org/10.1117/12.2314348
ACCESS THE FULL ARTICLE
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.
The alert did not successfully save. Please try again later.
Ricardo Ortiz, Joseph T. Williams, William Goble, "Lessons learned from wet washing the 6.5m MMT primary mirror in-situ," Proc. SPIE 10700, Ground-based and Airborne Telescopes VII, 1070004 (6 July 2018); https://doi.org/10.1117/12.2314348