Paper
1 May 1994 Strain-sensitive polymer composite material
Vitaliy G. Shevchenko, Anatoliy T. Ponomarenko, Carl Klason
Author Affiliations +
Abstract
Composite materials were synthesized by direct polymerization of propylene on the surface of natural or synthetic graphite particles. The method ensures grafting of polymer to a part of filler particle surface, while the other part remains open to physical contact between the particles, the resulting properties of the material becoming favorably different from previously known composites. Coefficient of strain sensitivity K equals (Delta) R/R(epsilon) (R is resistance of the sample, (epsilon) is tensile strain) was measured at different concentrations of filler and different temperatures. There is a broad maximum of K around the percolation threshold (4.5 vol.% for natural graphite) with a peak value of 100 - 150, which is much higher, compared to conventional wire resistors. A slight hysteresis is observed at unloading due to plasticity of the matrix. Hysteresis disappears, when temperature is lowered by 20 - 50 degrees, or (epsilon) is less than 1%, but previously high value of K remains. Below the glass transition temperature K is very low. The results are explained by the change of current- carrying chains in loading-unloading cycles. Temperature dependence of resistance is presented, thermal conductivities were calculated for different models and compared with experimental values.
© (1994) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Vitaliy G. Shevchenko, Anatoliy T. Ponomarenko, and Carl Klason "Strain-sensitive polymer composite material", Proc. SPIE 2189, Smart Structures and Materials 1994: Smart Materials, (1 May 1994); https://doi.org/10.1117/12.174082
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Composites

Polymers

Particles

Resistance

Polymerization

Temperature metrology

Carbon

Back to Top