Paper
24 September 1997 Replication of optical components using a silicone rubber intermediate replica
Daniel J. Daly, R. A. Ferguson, Michael C. Hutley
Author Affiliations +
Abstract
Silicone rubber may very conveniently be used to cast a mold from a variety of surface-relief optical components and surfaces. From this it is very simple to cast replicas in epoxy resin. The method owes its success in a large part to the flexibility of the rubber mold which eases the process of separation both from the master and from the final replica. However, the flexibility also gives rise to distortions in the final replica. This paper reports preliminary work to quantify these distortions under various casting conditions.
© (1997) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Daniel J. Daly, R. A. Ferguson, and Michael C. Hutley "Replication of optical components using a silicone rubber intermediate replica", Proc. SPIE 3099, Micro-optical Technologies for Measurement, Sensors, and Microsystems II and Optical Fiber Sensor Technologies and Applications, (24 September 1997); https://doi.org/10.1117/12.281257
Lens.org Logo
CITATIONS
Cited by 2 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Silicon

Optical components

Epoxies

Diffraction gratings

Moire patterns

Optics manufacturing

Glasses

Back to Top