Paper
11 March 2002 CD metrology on OPC features using light optical and electron optical tools
Thomas Schaetz, Stefan Doebereiner, Gerd Scheuring, Hans-Juergen Brueck
Author Affiliations +
Abstract
TO enable lithography at low k1 factors, OPC on photo masks is a method of strong and growing importance. But CD metrology of OPC features is suffering form several drawbacks: (1) OPC structures often do not have two parallel edges, which are required for usual CD metrology methods; (2) There are no commonly agreed standard definitions how and where to measure some types of OPC structures; (3) The CDs are very small; (4) There is no automated software for the measurement of OPC structures on operator level. A metrology method and a fully automated software for metrology of OPC structures based on LWM optical CD metrology tools is shown in this paper. It automatically distinguishes between hammerheads and serifs in various orientations. The method works analog to pitch measurements and requires only pitch calibration and no additional CD calibration. The results of light optical metrology tools with i-line and DUV wavelength is compared to CD SEM results.
© (2002) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Thomas Schaetz, Stefan Doebereiner, Gerd Scheuring, and Hans-Juergen Brueck "CD metrology on OPC features using light optical and electron optical tools", Proc. SPIE 4562, 21st Annual BACUS Symposium on Photomask Technology, (11 March 2002); https://doi.org/10.1117/12.458298
Lens.org Logo
CITATIONS
Cited by 4 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Optical proximity correction

Critical dimension metrology

Metrology

Photomasks

Scanning electron microscopy

Calibration

Halftones

RELATED CONTENT


Back to Top