Paper
10 January 2005 Analysis and design of low chromatic dispersion in flat-top AWG with parabolic waveguide horn
Fei Wu, Daqing Zhu, Tao Sun
Author Affiliations +
Proceedings Volume 5623, Passive Components and Fiber-based Devices; (2005) https://doi.org/10.1117/12.572937
Event: Asia-Pacific Optical Communications, 2004, Beijing, China
Abstract
An effective way of constructing an AWG with a wide passband is to use a configuration with a parabolic horn as the input waveguide to a slab waveguide. This configuration provides good passband control ability and fabrication stability. However, the parabolic waveguide horn may induce chromatic dispersion (CD) in AWGs. In this paper, first the theory of broadening passband and origins of CD in AWG were analyzed, then the influences of the configuration parameters of parabolic horn to broaden spectrum of AWG were discussed through a beam propagation method (BPM) and numerical calculation. A good flat-top AWG was obtained by choosing rationally three parameters: exit width W, broadening coefficient α and length of multimode waveguide. And low CD was achieved through adjusting the length of multimode waveguide slightly.
© (2005) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Fei Wu, Daqing Zhu, and Tao Sun "Analysis and design of low chromatic dispersion in flat-top AWG with parabolic waveguide horn", Proc. SPIE 5623, Passive Components and Fiber-based Devices, (10 January 2005); https://doi.org/10.1117/12.572937
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Waveguides

Dispersion

Beam propagation method

Demultiplexers

Dense wavelength division multiplexing

Electronics

Wave propagation

Back to Top